Electrofusion Safety Fittings can be fused to all PE pipes wit-hin MFR 190/5 in the range of 0.2 – 1.7 g/10 min. and pipe SDR Range 17.6 to 11. For installation on other pipe SDR please contact IPEX.
– Verify the pipe O.D. and the ovality. The pipe O.D. must be within the tolerances of the applicable pipe standard. Make sure to check and measure pipe ends for toe-in. If pipe toe-in O.D. is smaller than nominal pipe O.D., this pipe end MUST be cut back before installation! If you are unsure, contact IPEX for further information. Clean pipe of rough contaminations.